Practice Quiz

CompTIA Server+ - Question List

Select how would you like to study

Study Mode Free Daily Question Test Mode
71. Which of the following termination types does SCSI-1 networks normally use?
  1. Active
  2. HVD
  3. Passive
  4. LVD
See answer
72. Which of the following SCSI interfaces uses one half of the wires for the cable that transfers data and control mechanisms and the other half for a ground point?
  1. SE
  2. LVD
  3. FPT
  4. HVD
See answer
73. Which of the following specifies the prime difference between UTP and STP networking cables?
  1. STP has an additional layer of insulation surrounding the four-pair wire bundle.
  2. UTP has an additional layer of insulation surrounding the four-pair wire bundle.
  3. UTP ha an additional foil shield surrounding the four-pair wire bundle.
  4. STP has an additional foil shield surrounding the four-pair wire bundle.
See answer
74. Which of the following technologies will support an array composed of five servers handling 400 hard drives?
  1. Fiber Channel
  2. IEEE 1394
  3. Ultra ATA-33
  4. Ultra ATA-66
See answer
75. You have attached a SCSI scanner to a server. Prior to the scanner installation, all the devices attached to the systems were working properly. After the installation, the system does not boot properly. Which of the following could be the most likely cause of this issue?
  1. Scanner is not terminated properly.
  2. Scanner is not connected to the network.
  3. Scanner is not powering up.
  4. Server is disconnected from the network.
See answer

Select how would you like to study

Study Mode Free Daily Question Test Mode