Practice Quiz

FE Civil Engineering Exam Prep - Question List

Select how would you like to study

Study Mode Free Daily Question Test Mode
51. Which of the following best describes the term maximum bending moment in a beam?
  1. Point along the beam that will deflect the furthest from the normal plane
  2. Point at which shear forces change from positive to negative within the beam
  3. Point at which a beam will fail due to bending
  4. All of the above
See answer
52. Which of the following assumptions regarding the compression strength of concrete used in reinforced concrete beam design is valid?
  1. The American Concrete Institute (ACI) recommends that all beams be designed using high strength concrete
  2. High strength concrete compression strengths range from 3,000 to 7,000 pounds per square inch
  3. Compression strength of normal concrete ranges from 3,000 to 7,000 pounds per square inch
  4. None of the above
See answer
53. What is the proper sequence of steps to construct a dewatering wellpoint system for a construction excavation? 1. Connect header pipe to suction pumps 2. Jet wellpoints into the ground 3. Connect wellpoints to header pipe with riser 4. Fill annular void with filter media
  1. 1, 2, 3, 4
  2. 3, 1, 2, 4
  3. 2, 4, 3, 1
  4. 1, 3, 2, 4
See answer
54. Why is C considered to be a low-level programming language?
  1. It gives the programmer direct control over memory and hardware.
  2. It is usually learned early in a programmer’s education.
  3. It is not as powerful as some other languages.
  4. It is only useful for simple tasks.
See answer
55. Which of the following answers best describes why is it important to use critical path project management tools?
  1. To ensure consistent reporting and project benchmarking
  2. To produce reports or graphics that are easy to understand
  3. To obtain the information needed to assess the cost, status or performance of the project
  4. All of the above
See answer

Select how would you like to study

Study Mode Free Daily Question Test Mode