Advanced Networking Administrator Test Prep - Question List

Select how would you like to study

36. You are a network administrator at an organization. One of the routers on your network learns two routes to a remote network, one route via OSPF and another via RIP v2. You want the router to add the route learned via RIP v2 into its routing table. What should you do to ensure that the router will use the route learned via RIP v2?
  1. Configure the router interface on the OSPF path to a passive one.
  2. Configure the routers on the OSPF path to a lower priority.
  3. Configure the administrative distance of RIP v2 to be lower than that for OSPF.
  4. Configure the path using RIP v2 as a static route.
37. You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines. What command would assign this access list to the Virtual Terminal Lines?
  1. router(config-line)# ip access-group 1 in
  2. router(config-line)# ip access-list 1 in
  3. router(config-line)# access-class 1 in
  4. router(config-line)# access-line 1 in
38. You have been assigned the task of connecting a new switch to an existing switch. You want to set up the VLAN Trunking Protocol to enable VLAN information passing between the switches. Which of the following should you do to accomplish this?
  1. Set each end of the trunk line to IEEE 802.1e encapsulation.
  2. Set all ports on the two switches as access ports.
  3. Configure one of the switches as a VTP server.
  4. Connect the switches using a rollover cable.
39. An organization has an Engineering department with 25 employees. Currently all employees in the organization are on the same network. The Engineering team is concerned about other employees being able to capture packets going across the network and obtain sensitive material. What could a network administrator do to protect Engineering network traffic from being accessed by other employees?
  1. Install anti-virus software on all of the computers.
  2. Power down the switches that connect to the Engineering team computers when they are not in use.
  3. Remove other employees’ computers from the network and put them on a peer-to-peer network.
  4. Configure the Engineering team computers on a separate VLAN.
40. Which of these WAN encapsulation types can be configured on an asynchronous serial connection?
  1. HDLC
  2. SDLC
  3. Frame Relay
  4. ATM

Select how would you like to study