Practice Quiz

Advanced Networking Administrator Test Prep - Question List

Select how would you like to study

Study Mode Free Daily Question Test Mode
66. You have implemented a new Frame Relay network in your organization. However it is not functioning properly, since the inverse ARP is working erroneously. Which of the following commands should you use to provide connectivity?
  1. frame-relay arp
  2. frame-relay interface-dlci
  3. frame-relay lmi-type
  4. frame-relay map
See answer
67. Which of the following Frame-Relay encapsulation commands should be used to connect a Cisco router to a non-Cisco router?
  1. R1 (config-if)# Encapsulation frame-relay dot1q
  2. R1 (config-if)# Encapsulation frame-relay isl
  3. R1 (config-if)# Encapsulation frame-relay aal5snap
  4. R1 (config-if)# Encapsulation frame-relay ietf
See answer
68. David is a network administrator. He has forgotten the password to one of your routers. After a password recovery procedure, the router returns to its normal operation. What is the value that the config-register set to after the password recovery?
  1. 0x2102
  2. 0x2112
  3. 0x2104
  4. 0x2142
See answer
69. One of the workgroup switches in your organization is configured with all ports assigned to VLAN 3, where all ports are configured as full-duplex Fast Ethernet. What is most likely to happen when switch ports are added to a new VLAN on this switch?
  1. This will lead to more collision domains.
  2. IP address utilization will be more efficient.
  3. One more broadcast domain will be created.
  4. The probability of a switching loop will increase.
See answer
70. You are the network administrator at your organization. You need to ensure that a web server in your internal network is accessible from the Internet. Since the network uses private addressing, you have configured IP-to-registered-address mapping using the following command on the router:

R1 (config)# ip nat inside source static 192.168.4.2198.18.4.254

Many users are complaining that they are not able to access the web server from the internet. You first try to ping from the internet, without much success. You then issue the show IP NAT translations command and obtain a blank output. Which of the following issues related to this NAT configuration could it most likely be?
  1. You have entered an incorrect command.
  2. NAT has to be configured on all the interfaces.
  3. NAT pool should be defined.
  4. An access list must be defined to create static NAT translations.
See answer

Select how would you like to study

Study Mode Free Daily Question Test Mode